CISCO 828 SDSL Config

Hi

I am not an expert at CISCO products but I am able to configure simple routing via the command line

Anyway, I have a CISCO 828 Router and I want to use it on a UK SDSL line. I able to set it up in NAT mode and it works fine.

But, what I want to do is set it up in non NAT mode so that I can user the block of public IP address behind the router.

I think I am after a bridge config. So far I have been unable to find any example on the net or on CISCO web site.

Can any one provide a sample config or URL with the info

Thanks

RC

Reply to
RC
Loading thread data ...

Hi, can you please post the config with Nat and what you have tried without nat.

thanks.

Craig.

Reply to
corb

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.