1. Home
  2. Cisco Systems
  3. cisco 1811

cisco 1811

Using the SDM, I set up the cisco 1811 FE0 to connect to a static IP and got it setujp with the iP and mask, where do I set set the DNS?

I tried to follow the instruction from the test conneciton result, but I dont get it:. I think there is an DNS problem

Go to 'Configure->Interfaces and Connections->Edit Interface & Connection' and change the encapsulation. 2. If this is an unencapsulated interface, verify that the cable is properly connected. Retest connection.

The error was for for no configured DNS

Reply to
GG
Loading thread data ...

I have never used the SDM, but dns is a global command and will be set on the device as a whole, not just an interface. Try to look at the more generic settings menus.

Here is a comprehensive guide:

formatting link

Reply to
Trendkill

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.