Hi,
I'm trying to get an old 1605-r up and running. However, I keep getting
1d02h: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
1d02h: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
1d02h: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
1d02h: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
When e1 is connected via crossover to a switch, link light blinks intermittently. e0's link is solid with the same.
I've tested with a loopback plug, no link. e0 is solid with loopback plug.
My boss says it's a firmware issue, but: 1) I can't find anything on cisco's site about a firware upgrade for the 1605-r (it's end of life as of 200508) and 2) I think it's simply a hardware issue.
Thoughts, opinions, advice greatly appreciated.
-Jeff