What's the necessary steps in sequence to configure DDR on a ISDN Bri interface?
Sybex has the sequence as follows, page 512
Boson has it, Chapter 10 Page 19
Cisco Press Self Study ICND, page 342
Going NUTS Steve C.
There is no dependency on the configuration of interface IP address and encapsulation, dialer-string and dialer-group.
KPLAB
while there may be no official order and that any of the above would apply and get DDR working, I would make sure that the interface was shutdown first, the encapsulation chosen before setting an IP address just to rule out problems with the router choosing to work on the connection with the prior chosen or default encapsulation (HDLC). Then finally, to bring up the connection i would issue a `no shutdown` command.
Here is a config that i used that worked.
access-list 111 permit tcp any host 172.28.3.5 eq 25 access-list 111 permit tcp any host 172.28.3.5 eq 80 ! dialer-list 2 protocol ip list 111 ! interface bri 0 shutdown encapsulation ppp ip address 172.28.3.4 255.255.255.0 dialer string 1465142533 dialer group 2 no shutdown
Regards, Shalom
kplab wrote:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required