Cisco 2513

I just purchased a Cisco 2513 to prepare for the ccna exam is it possible to use this router with my cable modem.

Reply to
networknic
Loading thread data ...

Depending on the IOS you're running you just need to set the eth interface that terminates your cable modem to get its IP address via DHCP. Something like this:

interface FastEthernet0/1 ip address dhcp

You'll also need to set up NAT and your default route to your provider. With an ACL set up for NAT and port forwarding should you need it requires a little more research but is something you should learn to do.

Reply to
sombs

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.