I am not sure if this is the right forum to post to, but I saw another post on bridging so I thought I would give it a try.
I have a cat 5509 with an ATM interface at the north location, and a
5500 with an ATM interface at the south location. In between them are two igx wan switches, I don't know if that matters.
At the north location there is a 10.100.198.0 255.255.255.0 subnet. At the south location there is a 10.1.0.0 255.255.0.0 subnet.
I would like to create a vlan (or whatever interface I need) on the
5509 at the north location in the 10.1.0.0 255.255.0.0 network and bridge the two.
I am assuming I use IRB
how should I configure the ATM interfaces?
How should I configure the other interfaces?
Are there any good articles on this?
Thank you, Matt