I've got my firebox as 192.168.111.1 and I gave the Linksys 192.168.111.5. I still can't access the Linksys.
When I hook directly up to it I can access it.
Do I need to put it in bridge mode or something?
Can I use it as an access point?
Thanks.
Bryce.
I'll give it another shot then. Since somebody has done it, obviously I've just set something up wrong.
Thanks.
Bryce.
"Bryce" wrote in news:1nvCe.8$ snipped-for-privacy@news.uswest.net:
All I did was disable DHCP on the BEFW11S4 v1 router, set the device IP to
192.168.111.2, took the router out of *gateway* and put it into *router* mode, configured the router to use static the IP set-up pointing to the WG at 192.168.111.1 -- not using DHCP setup that would be to obtain IP from the WG for the router, and connected it to a LAN port on my WG Firebox III SOHO 6. I could access the Linksys router at 192.168.111.2 with the browser.The Linksys just became a wire/wireless AP *switch*.
Duane :)
"Bryce" wrote in news:eUwCe.393$ snipped-for-privacy@news.uswest.net:
The above is in the link below.
You can use it as a guide.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required