I need to install a Cisco A/P and two Cisco ANT1728 antennas.
The antennas have a threaded hole in them for mounting which would be used to attach them to the stud of a supplied T bar clip.
I need to devise a different mount instead of the T bar clip. I don't have the antennas yet and need to install as soon as I get them so I was trying to have what I need on hand.
I don't have one of these antennas, but I think I can guess the thread size. The above URL specifies using a 7/16" wrench on the nut. That neatly fits a common 1/4-20 nut.
Disclaimer: This is only a guess.
Good guess, I bought some beam clamps at the local electrical supply house and used a small bolt in the "wrong" direction as a stud.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required
