Hi, I am having Senao ECB-3220 wireless../ Yesterday I updated its firmware with NCB-3220 from Senao site. Everything went fine../ I was able to configure it as AP../ Finally, when I change the wireless from AP to bridge mode, it displayed that the ip has been changed to
192.168.1.1../ I then tried to open the page using same IP../ But after then everything was dead../ I can't open the site and even I can't ping the IP of the device../ Though using arp I can see the IP address with it's mac but no success../ I resetted the device several times using its reset button, but no improvement../ Can anybody help me out..? is the device totally dead..?
I would be happy if somebody could help me out../
Rgds, Dhiren
------------------------------------------------------------------------ View this thread:
formatting link