Adding a WI-FI connectivity to an existing wired LAN

Buy them both at the same time as wireless will not work with just one. That said, if you get the Laptop, it can be ethered in but no wireless.

I don't think it makes difference as to when you get them.

Duane :)

First, you decide what you want to do (as above). Then, you decide how much money you want to spend on this exercise. The dollar limit will determine what you can afford to buy. Make sure everything will do 802.11g.

Most new notebooks come bundled with wireless of some sort. Might as well take whatever the manufactory supplies at the client end.

Since you already have a suitable router, adding wireless can be done in 2 ways.

1. Replace your DI-704 with a wireless router. This is probably the easiest.
2. Convert a new wireless router into an access point and use the existing DI-704 router. This has several advantages. The access point can be turned off at night. The wireless part of the puzzle can be located up high in the room to get better range.

To convert a wireless router into an access point:

1. Ignore the WAN port. Nothing goes there.
2. Set the IP address of the router to something in the same Class C IP block as your existing DI-704 but on a non-duplcated IP address.

1. Turn off the DHCP server in the wireless router.
2. Run an ethernet cable between LAN ports on the DI-704 to the new wireless router. That should give you an instant access point.

Good luck.

I've just done this: my existing network is a one-port DSL router and a four-port switch with a web server wired in.

I bought a Belkin WAP and plugged it into my switch; and bought an HP nx6110 laptop with Intel wireless. Works perfectly.