Hi All,
I have been using FVS318 v1 and v2 routers for a while for VPN tunnels between client sites and they work great, as does the SafeNet 10 software. I cannot for the life of me get FVS318v3 to FVS318v1 tunnel to connect. I have tried to update the firmware, used FQDN and IP addresses, I notice that the v1 and v2 don't seem to use authentication and the v 3 seems to require it. I wish Netgear had never changed the interface or come up with the "Wizard". I could set up two of the old routers with a tunnel in about ½ an hour. I have been beating on this thing for a week. I have even replaced routers. Is there a comprehensive document that discusses the settings between FVS318v3 and FVS318v1? I am at a loss.
Thanks,
Bill Lobb