Telecom Technical

  1. Home
  2. Telecom Technical
1255 Threads Posts
to

R2 signalling

Hi, I have a question. Where are transmitted the multifrequency signals? (Time slot 16 uses four status bits for signal...
3 comments posted 21yrs
posted by tomasz.marczuk
3 comments posted 21yrs posted by tomasz.marczuk

Partner ACS low battery

Have a ACS with a continous low battery warning, even with new, tested, batteries. Starange but true, I have two the sa...
1 comments posted 21yrs
posted by sterrys
1 comments posted 21yrs posted by sterrys

CE-PE interaction

Does any one know how frames are forwarded from a customer edge switch to provider egde switch in a metro ethernet? Than...
1 comments posted 21yrs
posted by sriharshakn
1 comments posted 21yrs posted by sriharshakn

Alarms on CDM600

Hi all Hope I am on the right NG ;o) Anybody installed remote alarms systems on satellite modems CDM 600 from Comtech ?...
0 comments posted 21yrs
posted by none
0 comments posted 21yrs posted by none

Good books on GSM core protocols ?

Hi, I'm new to telecommunication world and protocols used in call signalling for GSM are a bit confusing for me. Can so...
1 comments posted 21yrs
posted by j.terrasson
1 comments posted 21yrs posted by j.terrasson

Newbridge 3600 51c

Hi Folks: Would someoneknow what '51C' means scrolling on the Control Card display? Would it cause a Dual T1 card to not...
0 comments posted 21yrs
posted by harryhydro
0 comments posted 21yrs posted by harryhydro

How do I code "drop" or "hangup" for TAPI?

I am working on a simple little TAPI capability in MS Access and cannot seem to figure out how to create a hangup or dro...
0 comments posted 21yrs
posted by chipg_98NO
0 comments posted 21yrs posted by chipg_98NO

Sending a different caller ID

Is this for real? Do they just send an audio signal to mimic the caller ID name/number you wish to send? http://codegods...
9 comments posted 21yrs
posted by reply_to_newsgroup
9 comments posted 21yrs posted by reply_to_newsgroup

Starting Dialogic Configuration Manager

Hello All, I am looking to start my dialogic using command prompt. How to achieve the same. Regards Ruchit Garg
2 comments posted 21yrs
posted by ruchitgarg
2 comments posted 21yrs posted by ruchitgarg

AD: Telecom Manuals

Attention Telecom Professionals! Are you tired of paying $15 for each telecom manual you need? We have a solution... Pl...
0 comments posted 21yrs
posted by jrojas
0 comments posted 21yrs posted by jrojas

VOIP

VOIP is changing the world: ------------------------------------- Wow this VOIP is growing so big. Just check the price...
16 comments posted 21yrs
posted by ljmonet_at_yahoo_dot_com
16 comments posted 21yrs posted by ljmonet_at_yahoo_dot_com