1. Home
  2. CCTV, Alarms and other Physical Security
  3. HELP! Ademco VISTA 20 P Zone Type 1 Won't Fault When Armed

HELP! Ademco VISTA 20 P Zone Type 1 Won't Fault When Armed

villain383 had written this in response to

formatting link
:

I have a Vista 20 P and I have three zones programmed with TYPE 1 that will not fault when the system is armed in either mode. When the system is unarmed the zones will fault with the chime and show faulted in the dispaly. The zones will also fault in the TEST mode and show on the display. They will not fault when the system is armed. Any ideas?

##-----------------------------------------------## Delivered via

formatting link
Internet Knowledge Base for the security industry no-spam access to your favorite newsgroup - alt.security.alarms - 44957 messages and counting! ##-----------------------------------------------##

Reply to
villain383
Loading thread data ...

Wait until your exit delay expires. Then wait another 10 seconds longer to keep the panel from going into Exit Error. It should work fine then.

Jim Rojas

villa> villain383 had written this in response to

Reply to
Jim Rojas

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.