Colleagues,
How can I figure out if an E1 link is operational or it is looped at the remote? I see no difference in the output of the command "d lp/1 e1/2" when I check.
Thanks in advance for any input.
detect remote loopback on MSS Passport
May 28, 2008
2 Replies
Set Test to manual Start test to see if you RX exactly the same amount of frames/bits that you tx
Perhaps I should look at the Shelf Card/*, not at Lp. However, what attribute shows that there is a remote loop?
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required