7 discussions on Cabling-Design.com Forums about the Linksys PAP2-NA: what owners asked, what went wrong, and what fixed it.
Hello All,Additional input. I was at the customers home yesterday and found the following.The wiring for line seizure was completed properly.The voltage for ON Hook was at 46.28 vdcThe voltage for OFF Hook was at 11.89 vdcThe RING voltage...
I just purchased the Linksys Phone Adapter with 2 Ports forVoice-over-IP.I intend to try it with the Vonage service, but I'd like to use it withmy own Asterisk PBX as well.I assume that this is not a Vonage-specific product.Has anybody out...
I have a Cisco 831 router on my home network. I have a numberof devices inside my network, all programmed with private, static IPaddresses. I also have a Linksys PAP2-NA v1 VOIP adapter which I amrunning two telephone lines with. ...
Sorry for if this sounds naive, but can anyone tell me if it'spossible to use e.g. a Vonage phone adapter, or a third-party SIPphone, with a connection from say, Packet8 etc.. In other words, dothe service providers tie you in to using...
I'm moving into a rooming house near Atlanta, Georgia. One ofthe tenants already has a cablemodem in the house. I'd prefer to havemy *own* cablemodem so I can use Putty.exe to gain access into myCisco 831 router while I am taking Cisco...
I have the above mentioned ATA. The instruction manual that came with it (a33 page PDF on disk) is nearly worthless. It doesn't even mention most ofthe features and configuration options on the set-up utility. There aresetting for two...