22 discussions on Cabling-Design.com Forums about the Cisco WIC-2T: what owners asked, what went wrong, and what fixed it.
I'm getting 3 or 4 Cisco 1721 to build a test lab for my CCNA study. At school,we used Cisco smart cable to connect two routers to act as WAN link. Most Cisco1721 on don't have this serial interface module cards. They usuallyhave a T1...
I am putting together a lab with two 2600 routers. I have two serialWICs: WIC 1DSU T1 and WIC 2T but I do not have a Smart Serial cable.If I buy one, can these two cards be used without an external CSU toconnect two routers...
Thanks in advance.Is it possible to run a back to back serial connection between a 2501and 2620?If so, what cabling would I require?If not, is there an alternative configuration for the topology below,or should I pickup another...
Folks:I would like to sell my CCIE Kit. I am actually getting out of the IT field and launching a brand new career in the Stock Market.Some of the equipment was bought new and some used. The 25xx routers were bought used, the others items...
Folks:I would like to sell my CCIE Kit. I am actually getting out of the IT field and launching a brand new career in the Stock Market.Some of the equipment was bought new and some used. The 25xx routers were bought used, the others items...
My office and remote office has two T1 lines. I am lookinng for arouter ( on each end ) that supports these two T1 lines. Searching onCisco site shows the series 1700 can support the module WIC-2T.My question is if this router and module...