21 discussions on Cabling-Design.com Forums about the Cisco C2950: what owners asked, what went wrong, and what fixed it.
Hi all:I have a Cisco 2950 and I'm trying to apply a simple ACL to blockpings from outside to our internal network.Here is the info on the switch:Cisco Internetwork Operating System SoftwareIOS (tm) C2950 Software (C2950-I6Q4L2-M), Version...
Hi,In a SuperStack II 3300 switch (model 3C16980), firmware 2.71, there are untagged and tagged VLANs. Am I correct to assume that ports defined in an untagged VLAN are partitioned off from other ports, into their own broadcast domain? ...
Hello,I've done some cisco configurations in the past without much issue.Usually, between books and the internet, I can figure just about anyof them out.. but this one is stumping me. Perhaps there's an IOSissue (like I have the wrong...
I am getting an awful lot of errors on interface vlan 1 on my Catalyst 2950'sAnyone have any idea what can cause this ?sh interfaces vlan 1Vlan1 is up, line protocol is up Hardware is CPU Interface, address is 0012.43a0.fb40 (bia...
I need to provide wireless access to customers in my customer lounge. I would like to hang a relatively inexpensive AP such as Linksys WAP54GX on one of my C2950 switches and allow these users to connect "only" to the internet. I know that...
I need to provide wireless access to customers in my customer lounge. I would like to hang a relatively inexpensive AP such as Linksys WAP54GX on one of my C2950 switches and allow these users to connect "only" to the internet. I know that...