I have an IR emitter whose adhesive has stopped working. It will no longer remain attached to my component. Anyone suggest an adhesive that would work, without permanently attaching the emitter? Thanks.
Pedro
I have an IR emitter whose adhesive has stopped working. It will no longer remain attached to my component. Anyone suggest an adhesive that would work, without permanently attaching the emitter? Thanks.
Pedro
If you're talking about a sender unit the size of a deck of cards, try
using picture hanging putty. It's available just about everywhere. It
will hold the unit good enough and won't leave a residual if you decide
to relocate it.
If you need something stronger, try stick on velcro tabs. Or, double
sided foam. Or even double sided tape but this tends to leave a
residual - easily removed but there nonetheless.
Many thanks for your advice.
Pedro
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.