Netscreen Remote and Symantec Firewall Client

- B
- Bucky Kim
  
  Contact options for registered users
posted
18 years ago

Mon, Nov 8, 2004 11:31 AM

I'm currently running Netscreen's Secure VPN Client SafeNet SoftRemote

10.0.0 build 10 and Symantec's client firewall version 7.1. Configured within the symantec firewall, I've enabled every application that Netscreen uses as well as enable the authentication ip address. But when the client firewall is enabled the connect is empty while when it's disabled, the connect shows my VPN connection. I'm wondering if there's a way to configure the symantec firewall to allow the Netscreen's VPN tunnel. Any help will be appreciated.

Loading thread data ...

- G
- Gary
  
  Contact options for registered users
Vote on answer
posted
18 years ago

Mon, Nov 8, 2004 1:10 PM

Try opening UDP port 500 for Internet Key Exchange (IKE) traffic. You might also need to permit IP Type 50 Encapsulating Security Payload (ESP) packets and IP Type 51 Authentication Header (AH) packets.

-Gary

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.