Juniper SSG-140 <-> PIX

Hello all,

I have severals problems with vpn connection because the proxy-id.

+--------+ +--------+ | LAN A | | LAN B | +--------+ +--------+

Networks over LAN A

10.20.33.0/24 192.168.244.0/23 172.16.0.0/16

In the Lan B

192.168.2.128/27

so i need 3 proxy-id, but in this juniper just permit one.

anybody have solution?

Regards,

ps: Sorry my bad english :(

Reply to
Jean Figueiredo
Loading thread data ...

+

Hey,

there are serveral solutions for that but it depends on you setup.

  1. You can define 1 IPSec SA and NAT all 3 Networks behind this address.

+-------+ | LAN A |->DIP Table 1.1.1.0/24->[WAN]

Reply to
Burkhard Ott

Hey,

i did try with policy based tunnel and this works :)

Thanks very much :)

Cheers,

Burkhard Ott wrote:

Reply to
Jean Figueiredo

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.