1. Home
  2. Networking Firewalls
  3. Firewall routing for P2P routers

Firewall routing for P2P routers

I recently had to reset to factory defaults on my watchguard SOHO 6 firewall and lost all my routes I had setup for two P2P locations. I thought I remembered how this was setup before but cant' seem to figure it out.

Here is our current setup.

Main Location --> LAN IP Address - 192.168.111.3/24 Serial 0/0 IP - 172.16.2.1/30 (P2P Location #1) Serial 0/1 IP - 172.16.3.1/30 (P2P Location #2) IP Address Range - 192.168.111.1-254 Subnet - 255.255.255.0 Gateway Address - 192.168.111.1 (Firewall)

P2P Location #1 --> LAN IP Address - 192.168.1.2/24 Serial 0 IP - 172.16.2.2/30 IP Gateway Address - 192.168.1.2 IP Address Range - 192.168.1.1-254 Subnet - 255.255.255.0

P2P Location #2 --> LAN IP Address - 192.168.3.1/24 Serial 1 IP - 172.16.3.2/30 IP Gateway Address - 192.168.2.1 IP Address Range - 192.168.2.1-254 Subnet - 255.255.255.0

All P2P routers are configured correctly and up and running. I believe it is just the firewall blocking the connection to the main location. Thank you in advance for your help.

Reply to
jeff
Loading thread data ...

so what is the problem you are having? no traffic getting through to the main site?? what are the results of a traceroute?

Flamer.

Reply to
die.spam

correct...figured it out yesterday. setup host routes on the firewall like these:

192.168.1.2 --> 192.168.111.3 192.168.2.1 --> 192.168.111.3 192.168.111.3 --> 192.168.1.2 192.168.111.3 --> 192.168.2.1
Reply to
jeff

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.