1. Home
  2. Networking Firewalls
  3. Checkpoint NG AI VPN nated

Checkpoint NG AI VPN nated

My VPN gateway is behind NAT device. Is it possible to achive VPN connectivity from SecureClient to this VPN gateway in this scenario?

thanks

Reply to
no
Loading thread data ...

This was asked only recently. Yes, you just need to make sure the relevant ports are forwarded on the NAT box to the gateway.

Reply to
Memnoch

Well i am not sure. My system does not have public IP on VPN gateway and I think it does not work because of that.

Reply to
Drx

As I said you would need to configure a Static NAT to the gateway. You could also configure the NAT device for bridging and give the VPN gateway the same address as the NAT device IYSWIM.

Reply to
Memnoch

Cisco router is in front of Chaeckpoint and NAT is done on Cisco router. If i but client behind router, VPN is ok, and if I put it on public side of router, VPN does not work

Reply to
no

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.