Time Changing

Dear Experts

I am very very new to network and routers.

In our CISCO2811 router, 4 WAN Interfaces cards connected to remote locations through leased lines. Time to time I used to check the log for disconnections. whenever I want to see the log it is showing in

-5:30 Hrs differance. What may be the cause ?

If it can be corrected to our INDIAN(IST) timing how it can be done ?

Please give me step by step commands to execute on router.

Thanks in advance

Regards

PS Prasad

Dear Experts

I am very very new to network and routers.

In our CISCO2811 router, 4 WAN Interfaces cards connected to remote locations through leased lines. Time to time I used to check the log for disconnections. whenever I want to see the log it is showing in

-5:30 Hrs differance. What may be the cause ?

If it can be corrected to our INDIAN(IST) timing how it can be done ?

Please give me step by step commands to execute on router.

Thanks in advance

Regards

PS Prasad

investigate these ....

ntp update-calendar service timestamps log datetime

The time is off but the date is correct? What do you get when you do a "show clock" command? Do you know the source where you are getting your time?

What is your current NTP configuration?

messagenews: snipped-for-privacy@13g2000cwe.googlegroups.com...

Dear BernieM

You got the point. I didn't mentioned in my request that thing. The router was installed by a third party they just installed and gone.

No time zone configuration was made.

That's why I am asking.

Thanks

Regards

PS Prasad

. snipped-for-privacy@13g2000cwe.googlegroups.com...

Thanks PS but it was cmd that mentioned the timezone setting.

Dear BernieM

Receved with Thanks

How I can change the Time Zone setting in my router ? Can you guide me step by step to change time zone to Indian Standard Time ( IST i.e. GMT + 05:30 Hrs).

Date is showing correct with time -5:30Hrs Late in my router.

I do want to change it to our IST.

Thanks in advance

Regards

PS Prasad

You can use this command:

clock timezone IST 5 30

also if you want your logs to show with the correct time, you can use:

service timestamps log datetime localtime

see the following if you have any questions: