I have a 2509 as a controller to access all the devices. It works with other devices ( from old 26xx,36xx to newer 28xx and ASA55xx ) but I cannot not use it with the switch 2960. And I can access the 2960 via the Cisco serial cable from my notebook. The 2960 configuration for console is empty, like others.
Any advice is greatly appreciated.
DT
DT -
I've just been doing exactly this today, no problem.
Sorry to state the obvious, but have you checked the following?
- the 2509's port does not have some unusual settings (speed etc)
- the 2509's port permits reverse telnet
- the line from the 2509 is not somehow broken (try another)?
HTH...
Andrew
On Wed, 19 Sep 2007 14:39:24 +0100, snipped-for-privacy@yahoo.com wrote (in article ):
Have something to add? Share your thoughts — no account required.
Ask the community — no account required