1. Home
  2. Cisco Systems
  3. Pix: Change the IP address of the inside interface

Pix: Change the IP address of the inside interface

I have a Pix 515E running 6.3(3). The inside interface is currently the gateway on the network (192.168.0.1). To meet some other routing requirements I need to add a router inside of the Pix and renumber the inside interface, moving 192.168.0.1 to the new router, thus:

Router Pix Eth0 Eth1 Inside Int

192.168.0.1 10.10.10.2 10.10.10.1

The Pix has quite a few static routes setup, and is performing NAT.

What's the simplest way to change the IP address of the inside interface and ensure all other settings are changed as necessary? Can the PDM be of help here?

Regards, Brian

Reply to
brankin
Loading thread data ...

I would save the config to a pc, edit, do a search/replace and then send the new config back to the pix.

Reply to
Scooby

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.