Need Info abt Frame relay fragmentation header

Hi All,

Our setup is like this :

Our test setup is as below :

1) For the MLFR side, Port 5 of Adtech(.153) was connected to Tigris 0/Evros 0. 2) For the FR side, Port 4 of Adtech(.153) was connected to Tigris 1/Evros 1.

Our Packet configuration :

1) IP over Frame Relay Traffic with channelised - DS3 configuration in the MLFR side with the following options set : DLCI = 16 Flags : C/R, FECN, DE with various combinations Control UI = 0x03 NLPID = 0xCC along with IP Packet Format in different modes set: 1) User Mode 2) IP editable Test Blocks. 2) But we are not getting that packet out from FR side.

We thought of adding "fragmentation header" with the packet , we have not seen any option for adding this.

Where can we get this option or any relevant information for the same in Adtech AX400.

Thanks in advance.