1. Home
  2. Cisco Systems
  3. Can Pix OS 4.1.4 support dhcp client on outside interface (eth0) ?

Can Pix OS 4.1.4 support dhcp client on outside interface (eth0) ?

Can Pix OS 4.1.4 support dhcp client on outside interface (eth0) ?

I have a PIX Classic (pre PIX 520) running PIX OS 4.1.4 I would like to plug the outside eth0 into my cable modem and have it receive an ip address via DCHP from my isp.

no error msg when i put in "config # ip address outside dhcp setroute" but it also doesn't do anything , ie the outside interface still stays at ip address outside 0.0.0.0 0.0.0.0. without "setroute" is the same

Reply to
nc12345
Loading thread data ...

I'm afraid that this feature was introduced in PIX OS 5.2(1) so with the earlier versions you have use fixed IPs.

Reply to
Jyri Korhonen

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.