Hi,
I recently migrated a PIX6.3.5 setup to ASA5505 7.2.2 The SOHO-user had a VPN for clients configured, and as you may know in PIX6.3 if you did not specify client-authen, you just connected right on, without user prompt etc. All you needed was group name and password
But I noticed that the behavior for the exact same config in ASA7.2.2 gives you the user prompt in the Cisco VPN client. I can find no config statements that tells the ASA to use LOCAL authen., but still it does. Hence this must be a defaultRAGroup behavior.
Where can I read more about this and are there any commands to would turn the ASA back to the PIX behavior ?
HTH Martin