1. Home
  2. Cisco Systems
  3. 851 configuration

851 configuration

WIN2KSERVER---Hub---USRouter---Switch---DSRouter---Hub---Workstation

We have setup 2 small LANs on an existing network, one upstairs(USRouter) and one downstairs(DSRouter). USRouter has

192.168.3.0/24 inside and static 10.200.1.28 on WAN. DSRouter has 192.168.9.0/24 inside and static 10.200.1.29 on WAN. Both routers are Cisco 851s. We have put static routes in each router to opposite router's 192 network: ip route 192.168.3.0 255.255.255.0 10.200.1.28 ip route 192.168.9.0 255.255.255.0 10.200.1.29 We can ping from DSRouter to WIN2KSERVER, but not from Workstation. Firewalls have been disabled on all devices to troubleshoot. Workstation cannot get to WINServer. Both routers have very simple config., basically out of the box. Both are NATing. Is there an ACL or something that we are missing? Any help is appreciated. Thanks, Dave.
Reply to
drhopkins
Loading thread data ...

Hi Dave,

You may wish to investigate the Cisco 851 Config Wizard:

formatting link
Hope this helps.

Brad Reese Cisco Router Port Matrix

formatting link

Reply to
www.BradReese.Com

An what route do the workstations have?

Reply to
chris

NAT?

Best post the whole (sanitised) config.

no usernames/passwords and changed public IP addresses.

I find

sh tech xxxx

where xxxx is a feature that you have but are not using e.g. ospf is very handy since it limits the output of the sh tech but still includes the config with some sanitisation.

Reply to
Bod43

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.