All
In the boson test there is a question that states the following Which of the following would be displayed by the command "SHOW CDP NEIGHBOR DETAIL" a) The incomming/outgoing port b)The routers hostname c) Ammount of Flash Memory Available d) The Subnet Mask , if IP is configured e) The hardware platform f) One address per protocol
Now I know that A ,E and F are correct however they say it also shows the hosthname, see below output from a router at work and let me know where I am going wrong
Telehouse-1>sho cdp neighbor detail
------------------------- Device ID: Server_Room_Switch Entry address(es): IP address: 10.0.70.20 Platform: cisco WS-C2950T-24, Capabilities: Switch IGMP Interface: FastEthernet2/0, Port ID (outgoing port): FastEthernet0/1 Holdtime : 135 sec
Version : Cisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(19)EA1c, RELEASE SOFTWARE (fc2) Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Mon 02-Feb-04 23:29 by yenanh
advertisement version: 2 Protocol Hello: OUI=0x00000C, Protocol ID=0x0112; payload len=27, value=00000000FFFFFFFF010221FF000000000000001121816B40FF0000 VTP Management Domain: '' Native VLAN: 1 Duplex: full
------------------------- Device ID: Hydro_2950t Entry address(es): IP address: 10.0.77.20 Platform: cisco WS-C2950T-24, Capabilities: Switch IGMP Interface: FastEthernet0/1.1, Port ID (outgoing port): FastEthernet0/2 Holdtime : 179 sec
Version : Cisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(19)EA1c, RELEASE SOFTWARE (fc2) Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Mon 02-Feb-04 23:29 by yenanh
advertisement version: 2 Protocol Hello: OUI=0x00000C, Protocol ID=0x0112; payload len=27, value=00000000FFFFFFFF010221FF000000000000000FF79F6E40FF0000 VTP Management Domain: '' Native VLAN: 1 Duplex: full
Telehouse-1>
At no point in there other than at the command line do I see the routers name Can anyone advise at all?