Q.1 If I wanna get into line 2 of a router, is this a valid command:
RTR(config)#line 2 RTR(config-if)#
Q.2 Is 'no shut' needed in line and loopback interfaces?
thanks in adance
Q.1 If I wanna get into line 2 of a router, is this a valid command:
RTR(config)#line 2 RTR(config-if)#
Q.2 Is 'no shut' needed in line and loopback interfaces?
thanks in adance
Q1, line 2 is a valid command and will bring you into the configuration of line 2. The prompt you have given is incorrect tho, it would show RTR(config-line)# not config-int
Q2, NO, by default they are already administratively up.
-Brian
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.