Hello all.
I'm trying to use Cisco IOS udp-small-servers to measure round-trip latency and packet loss. I'm sending the echo's from WAN-link (another site) and using the LAN address as a destination address. As we are running the voip from the far end I'm trying to measure, I need to get the UDP Echo-traffic also to the same policy map as the voip traffic.
Now it seems to work so, that the destination router is sending the answer packets (echoing them) right from the link interface and not routing them through the LAN-interface and VLAN's/policy maps as we would like to.
I cannot find ANY documentation regarding this kind of configuration, only a basic enable/disable the echo service.
Thank's,
Jannar.