Senao 2611 CB3 Deluxe Challenges

Skip - Working on the boat · 2006-07-02T13:49:00+00:00

New topic heading - Jeff Liebermann had posted on this subject inanother thread:Thanks, Jeff, for the post. Just a couple of comments inline:Jeff Liebermann wrote:I'll try googling for a good report. With any luck it will show up insomething like this and I can actually get to talk with someone abouthow they succeeded. I'm hopeful of getting a cogent (well,technically, *any* response would be somewhat surprising) reply to avery complete RFH from Senao corporate tech support.I don't have a clue (perhaps you could help?) about how to furtherseparate. Just as a basis (removed during the ethernet portions of thetest), I have a Hawking USB antenna. I'ts what makes this postpossible. It also (with its configuration utility) tells me the SSID,Mac and strengths of all the visible SSIDs. At least fair for seeingwhat to expect from the Senao gear.With the internal wifi card disabled, and the Hawking unplugged, I setabout solely to make (one of the) units perform as a bridge. Perhapsit's a matter my expectations. As already specified elsewhere, I amclueless about networking minutiae. However, what I expected was to beable to find an AP and communicate with it, through an antenna attachedto one of these units configured as a bridge, in much the same fashionas I do with my internal wifi antenna (disabled for all but the mostinfrequent appearances outside either my home or boat) or my USBantenna. So, if that's the problem, you're quite right, I need tostart over. "Over" in the most basic sense, too, as, if I can't do itas above, I clearly don't have any clue about what hardware is requiredto get me communicating with a remote AP...Onward to separation and defeat (so far, any way):1) The ethernet portion of my testing setup seems to work just fine,as demonstrated by my ability to configure the card when connected(more below). I can reliably configure it to DHCP or specify IP andsubnets, along with extras in the advanced section, in the event Iwanted to use it to...

Jul 02, 2006 22 Replies

Rate this thread:

Skip - Working on the boat 20 years ago

Hi John, and group,

Back > 1. That's baloney. See

I'm beginning to learn that whatever a senao rep/distributor says is unreliable. Jeff was kind enough to point out that the same was true of Antnenae manufacturers (or maybe just marketers)...

(clip g superiority proofs)

I do, I, know, I do, and I did (before moving on beyond that point earlier last week). More later when I get it out again, which I hope to do this week. I finally got Lydia to see that this was a worthwhile use of time, so I may get to pursue it a bit more aggressively...

L8R

Skip

Vote