I have a working RV042/RV042 wite-to-site VPN. I need to replace one end with an SSG-5. I've not set up an SSG-5 before but it seems more or less "OK" and will be better as soon as I really figure out what "objects" and "addresses" and "policies" are....
But, following canned instructions and with some help from tech support I've been able to get the SSG-5 set up. Yet, no connection. I don't see the VPN / tunnel listed in the Interface link status: ... should I? Seems like. Wouldn't know where else to look. (The RV042 reports the VPN status on the VPN summary page - and it's not connected).
I have this all set up in a lab with a router simulating the internet connections (both public IPs are on the same public subnet)- so it's easy to try things at both "ends".
Any help / advice would be appreciated.
Fred