Netgear FVS318 to FVS318 - no tunnel - take a look at my settings - what am I missing?

Jun 07, 2005 0 Replies

Both PC's and routers are online - I have yet to establish a tunnel - something I have wrong or am overlooking, please look through these settings and tell me what I am missing or have wrong



Till I get this configured, firewalls are down



Thanks --



__________________________________



gateway A = Home office - will be main location



Gateway b = Business location 1



__________________________________



gateway A = Wan IP changes with DHCP -but am using current one on lease



xxx.xxx.xxx.127



internal IP gateway A (VFS 318v3) is 192.168.0.1 subnet mask of 255.255.255.0 default gateway of 192.168.0.1



IP's of internal PC's are 192.168.0.2 and .3



Gateway B Wan Ip xxx.xxx.xxx.57



internal Ip (VFS 318v3) is 192.168.1.1 subnet mask of 255.255.255.0 default gateway of 192.168.1.1



internal PC ip's are 192.168.1.2 and .3



________________________________



Ike policy settings are



Both directions



Main mode



local and remote IP addresses are correct and have been double checked



- the opposite for both locations



________________________________



IKe SA settings are



preshared key qwertyqwertyqwerty



Triple DES



SHA-1



DH group is group one



SA lifetime of 28800 seconds



_______________________________



VPN policy settings



are with same name



remote VPN adresses are correct and double checked - merely the opposite for both locations



Traffic selector is subnet address



Start IP address: ... 192.168.0.1 Finish IP address: .. greyed out Subnet Mask: ... 255.255.255.0



Remote subnet address



Remote IP - 192.168.1.1 Finish IP address: ... greyed out Subnet Mask: ... 255.255.255.0



AH configuration is _not_ enabled



ESP config is



Enable encryption



Enable authentication



netbios enable


Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required