cable com rs-232 to switch "baystack 350-24T"

Hi

I need scheme to make cable which is connecting pc with baystack 350 to set switch up by telnet.

Here is link to manual of my baystack:

on page 245 is scheme how connect pins, but there is only one side...

I thing It should be like I drow it under? There is a view of cable with two plugs... ___ ___ / \\ / \\ | \\ | \\ | 1 ---------| --- |---- 1 | | 6 ----| --- |-------- 6 | | 2 ---------| --- |---- 2 | | 7 ----| --- |-------- 7 | | 3 ---------| --- |---- 3 | | 8 ----| --- |-------- 8 | | 4 ---------| --- |---- 4 | | 9 ----| --- |-------- 9 | | 5 ---------| --- |---- 5 | | / | / \\___ / \\ ___ /

1 CD Carrier detect (not used) 2 TXD Transmit data (output) 3 RXD Receive data (input) 4 DTR Data terminal ready (not used) 5 GND Signal ground 6 DSR Data set ready (output always asserted) 7 RTS Request to send (not used) 8 CTS Clear to send (output always asserted) 9 RI Ring indicator (not used) Shell Chassis ground

thanks for your help...