I have a BCM running 3.5 with a 4x16 line/extension card at Bus 05, offset 0. I tried to add another 4x16 card into the system at Bus 03, offset 0. According to the documentation, this should work since the the second Bus gets taken over by the card to do extensions.
When this is set up however, the new card doesn't get recognized by the BCM. If I go into the diagnostics within the web interface, I don't see the module there as installed/enabled within the media bay modules. Further, I don't see the trunks within the line listing of active lines.
Any ideas?
TIA, Ed