9 discussions on Cabling-Design.com Forums about the Cisco 2600XM: what owners asked, what went wrong, and what fixed it.
Hi all,I need hel all of youI need to deploy 2 routers using serial interfaces on differentlocationsOne Will be used for 2 Mbps serial link and other will be used for 4MbpLink.I need to know which model support for 2Mbps and 4MbpsCould you...
I am putting together a lab with two 2600 routers. I have two serialWICs: WIC 1DSU T1 and WIC 2T but I do not have a Smart Serial cable.If I buy one, can these two cards be used without an external CSU toconnect two routers...
Ok, I have purchased a "Cisco T1 DSU/CSU WAN Interface Card(WIC-1DSU-T1-V2)" for a 2600 sereis router that I have. Now the ciscowebsite specifaclly says the v1 version of the card supports both 2600and 2600xm, but the v2 table only shows...
Hi,I currently have a 2811 which is just used for data at the moment. I'm looking at signing up for a VoIP SIP service and configuring it on my 2811. This is new territory for me so to get me started, can someone advise what NM/WIC/HWIC I...
We'd a one of two T-1s in a Multilink PPP bundle go down. Annoying. Butthis also appears to have somehow "broken" the Multilink itself. VeryAnnoying.I'm on the Cisco side: a 3662 running 12.2(23a). I've removed the "bad"serial line from...
HelloI would like to ask you how to configure a Cisco 2600XM (with 2 FE ports) with an ADSL Line (RFC1483) and an external eth modem.I have a 2651XM, on FE0/0 I have an external ETH modem, on FE0/1 I have the LAN side 192.168.0.254/24With...