X10 collision problem

I have a lot of X10 transmiters an receivers connected on a house, with a CM11 controller. My problem is that I have detected that when a module is sending a signal (xej. A2 - ON), if other transmiter send other signal in that moment (xej. A3 - OFF) there is a collision on the line, and the signals don't transmit OK. Do you know how can I solve that conflict on my X10 installation? thanks!

Reply to
Loading thread data ...

Reply to
Dave Houston

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.