Omnipro 2 with a OnQ 4 branch ALC board

Hello, I have an Omnipro 2 with a OnQ 4 branch ALC board. I installed it just

like the instructions said. I dont know how to control it using the dealer software for Windows ver 2.4a. The status light on the alc board is blinking. How do you tell the Omnipro the the expansion alc board is installed?

Thanks in advance,


Reply to
Loading thread data ...

Enter setup, # for installer, 7 for expansion. Scroll with the down arrow, untill you find the module # that matches the jumper on the alc board, press # scroll down or up arrow until you find ALC.

In Pc Access, setup, installer, expansion.

Reply to
Brett Griffin Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.