Hi everybody,
I've got the following situation:
For testing I want to allow icmp traffic from the 10.11.96.0 /20 network to the 10.11.64.0 /20 network
PIX 515E Inside: 10.11.96.3 255.255.240.0 Outside: 172.31.255.9 255.255.255.248
Router Ethernet0/0: 172.31.255.10 255.255.255.248 Tokenring0/0: 10.11.64.0 255.255.240.0
Part of the PIX config: route outside 10.11.64.0 255.255.240.0 172.31.255.10 1 nat (inside) 0 access-list 100 access-list 100 permit icmp 10.11.96.0 255.255.240.0 10.11.64.0
255.255.240.0
Problem: When I want to use the command: "nat (inside) 0 access-list 100" I get the warning: "access-list protocol or port will not be used". I cannot ping any hosts on the 10.11.64.0 network.
Can someone help me? Marcel
-- Marcel
------------------------------------------------------------------------ Posted via