Site to Site VPN with PIX 515e and Linksys RV082

- R
- Richard
  
  Contact options for registered users
posted
18 years ago

Sat, Jan 21, 2006 5:17 PM

I've been trying to get a site to site vpn up and running between 2 sites, one with a pix 515e and one with a linksys RV082.

The VPN is connecting and staying connected, but after 5 minutes routing is stopping between the 2 networks and i'm unable to access anything across the tunnel until I disconnect and reconnect.

Any ideas what might be the problem?

Thanks

-Richard

Loading thread data ...

- W
- Walter Roberson
  
  Contact options for registered users
Vote on answer
posted
18 years ago

Wed, Jan 25, 2006 4:40 AM

5 minutes suggests that the route is timing out. If it were 3 minutes, most likely would be ARP entries timing out.

I'd be inclined to investigate the ARP situation first. You are probably using nat 0 access-list on the PIX: if so, then you need to know that proxy ARP is disabled for such IPs, and that can end up looking like the situation you are experiencing.

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.