pix Version 7.0(4) cluster move

hi, i have to physically move a pix cluster from one serverhousing to another.

how i would do it:

write standby write net ...

shutdown pix1

make sure pix2 is up and running with all vpn tunnels (what's the time frame I am expecting, when exactly is pix2 supposed to take over?)

move pix1 to new location, (switch is configured) and plug it into patchpanel, boot. tell noc to change routing wait till routing goes into effect,


check pix2 to see if all vpn tunnels are up sh isakmp (anything I have to do manually to get these up?)

THANK THE LORD (or cisco)

bring over pix1, plug it, boot. check if pix1 is active/active and pix2 is active/standby

any other commands to verify proper operation? cheers, M

Reply to
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.