Cisco 836 + NAT + DMZ

Hello,

Can I configure the Cisco 836 with NAT and DMZ ?

I have tried but when I write ip nat inside or ip nat inside I get:

Router(config-if)# ip nat inside

00:09:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface NVI0, changed state to up % PDL Error : Failed to compile regexp File : http.pdl Line : 1908 : (regexp store insensitive ^^^^^^^

% PDL Error : Failed to compile regexp File : http.pdl Line : 1985 : (regexp store insensitive ^^^^^^^

Thank you

Athan

Reply to
Athan
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.