Routing Protocols Over Async Back-To-Back?

I have set up two 2600 routers in a back-to-back configuration using the AUX ports. (One of my serial cards was bad, so I've had to get creative in order to build a lab.)

Connectivity is fine. But I cannot seem to get RIP or OSPF to pass information between the two routers. Is this possible?

Here is the interface and routing config from one of the routers:

interface Async65 ip address encapsulation ppp async dynamic routing async mode dedicated ! router ospf 1 log-adjacency-changes network area 0 network area 0

Here is a show ip ospf database:

Router-2#sh ip ospf database

OSPF Router with ID ( (Process ID 1)

Router Link States (Area 0)

Link ID ADV Router Age Seq# Checksum Link count 1582 0x80000002 0x00013A 2

sh ip ospf neighbor has nothing in it.


Reply to
Loading thread data ... Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.