Linksys WAP11 V2.8 Dead after firmware upgrade


Upgraded my wap to the latest firmware and now it does not react to anything anymore. I tried resetting the unit several times but it does not work. The setup utility run from a wired pc keeps failing to recognize the AP. Also the AP does not listen to the default web addresses anymore. Netstumbler does not see any channels anymore.

Is there any way to get my AP working again? or maybe another diag tool that analyses the problem a bit further?

Thanks Tom

Reply to
Loading thread data ...

Try a hard reset, most often (in my experience) after a firmware upgrade a hard reset is needed.

fundamentalism, fundamentally wrong.

Reply to
Rico Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.