Passport 7480 Static Ecmp

Hi, We have a passport 7480 running 7.2, and just want to configure static route ecmp with Cisco 2600, via E1 interface. From traffic monitor, we can see packets being sent from Cisco are shared. (We use per packet sharing). However, packets sent from Nortel always goes via one route.

There are two routes from 7480 to Cisco with same metric. We have set maxEcmpNextHops on nortel virtual router to 3, and we checked "protected static routeentrys" is disabled. Still not working.

Any ideas?

Thank you in advance.

Reply to
Loading thread data ... Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.