9 discussions on Cabling-Design.com Forums about the Netgear R7000: what owners asked, what went wrong, and what fixed it.
The current home router is currently set up as the LAN gateway on192.168.1.1 and it's set to get the WAN Internet IP address from the modem, and it's set to hand out DHCP addresses from 192.168.1.2 to 192.168.1.254.I've just now configured...
Have you ever uploaded firmware to a router using tftp?I am having trouble with uploading firmware and logging into a NetgearNighthawk AC1900 Model R7000 router over Ethernet on Windows 10 using Firefox (version 109.0.1) so I tried 'tftp'...
What do I need to do inside of Firefox to force it to use http and notconstantly switch to https? do I do inside of Firefox to force Firefox to ask for a routercertificate instead of just assuming it's always bad?It's a long story but the...
Which mode is used to set up a router as a wired repeater?I downloaded the manual but it doesn't explain how to set up the Netgear R7000 as a _wired_ repeater (aka wired range extender). are four modes. But none say they are a wired...
I realize most of you home repair and wireless router gurus probably already know all of this; but, it took me quite a while to figure out (from various sources) how to set up a spare Linksys WRT54Gv2 home broadband router as a wired...
I have a 3745 running off xmodem download. I need to get IOS ontopflash: or slot0: so I can restart as normal. If I try to "TFTP: flash:(or slot0:)" from my TFTP server it always fails at the same pointRouter#copy tftp: flash:Address or...