5 discussions on Cabling-Design.com Forums about the Napco GEM-P9600: what owners asked, what went wrong, and what fixed it.
I tried to get hold of you for quite some time today via the phone...I needed apci-mini and some other stuff. Since I couldn't get hold of you today, I pickedone up elsewhere :-(. Hopefully we cross paths at some point :-). I need tosetup...
Back in about '99 I installed a Napco Gemini P3200 panel with the GEM-AUTO firmware upgrade for home automation. I used it with Cyberhousesoftware for a while (remember Cyberhouse? Where'd it go?). I'mcurrently doing some upgrades around...
Lost power for extended period of time. Battery went dead. I have an Expansion Zone Module (EZM) and three partitions configured on the 9600. After power was restored, the following things are occurring:1-The EZM red LED is solid and the...
I was hoping someone could tell me how to adjust the time that an alarm rin gs for on the above referenced panel(It seems to continue to ring and I wou ld like to set perhaps a 30 minute limit). I have the master cose and would do it...
I was going to buy some Sentrol smokes for my house, but then I readabout some recalls on the model I was going to buy.What brand and model should I buy? I have a Napco GEM-P9600 panel.Should I buy 2-wire or 4-wire? The panel supports both....