5 discussions on Cabling-Design.com Forums about the Napco FG-730: what owners asked, what went wrong, and what fixed it.
Hello, I have installed a FG-730 on Napco p3200 with the following parameters NC loop with default 750ms response. programmed zone as 24 hr zone did not connect any wires to the tamper terminalEverything was looking fine until I tested that...
Hi:I am pre-wiring my new house under construction. I have a 76lbs greyhoundthat will be moving in with my wife and myself. I am preparing to run the4/22 shielded wire for the 8 motion detectors. Each bedroom will have onemotion...
Anyone using these? It's a glassbreak with a built-in door contact. I pulled one out of a binky install. Any good?
I do not use glass break detectors very often, and have not for about ayear now. Need to install about 10 in a new office building (allceiling mounted in offices). In your opinion(s) what brand and modelcould you recommend for this job? ...
Hi All:I'm trying to find some documentation for some glass break detectorsthat are built into the wall of a house I'm buying. I'm guessing thatthese are about 12 years old. They are manufactured by InternationalElectronics, Inc., model...